Change a Propane Tank
Forklifts fueled by propane are common in warehouse settings. These forklifts have a propane mount situated at the back of the driver. These tanks have to be replaced from time to time as they have limited lifespans. Operators of forklifts must utilize care when handling propane tanks. Compressed gases are hazardous, especially since the gas is flammable. Use caution when removing and replacing propane tank to prevent being injured.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn off the valve on the tank. Let the lift truck run until the engine dies. This process burns the gas off in the transfer hose that connects the tank and the engine. Before taking the next steps, wear the correct safety equipment, like insulated gloves made of either neoprene or leather. It is essential for you to protect your skin from contact with the compressed gas, that is extremely cold.
2 Disconnect the hose from the tank and take off the holding straps to remove the tank. When putting in a new tank, reconnect the holding straps and reattach the hose at the valve of the tank by tightening the nut.
3 Leaks can be inspected just by applying soapy water to the valve and slightly opening it. If there is a leak, it would cause bubbles to foam from around the valve. If this occurs, inspect the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks in the valve area, and after that do the leak inspection procedure over again. Persistent leaks mean that the nut and connecting hose must be replaced. Nonetheless, if replacing the hose and nut still does not stop the leak, the tank would need to be replaced.
4 Lastly, open the valve all the way to allow the gas to fill the connecting hose. Afterward you could start the forklift and continue operating.